The aim of this investigation was to find new approaches to evaluate the performance of low-consistency refiners. Data from a paper mill producing TMP from Norway spruce was used in order to find a possible way to calculate the power split between the zones in a TwinFlo refiner. An assumption of equal amount of fibres captured between overlapping bars was found successful in order to develop equations for the power split. The equations predicted equal power in both zones at equal disc gaps. The power was found to increase approximately linearly with decreasing disc gap over the range, 0.1-0.2 mm. The power split was essential to know for calculating refining intensities expressed as specific edge load and forces on fibres in the two zones. The reduction in fibre length was about 5% at 0.17 mm disc gap or at 0.03 N forces on fibres or at 0.7 J/m specific edge load. Disc gap, forces on fibres and specific edge load was found to predict fibre shortening approximately equally upon changes in power and flow rate through the refiner.