Nanocomposites of carbon black nanoparticles (CBNP) and crosslinked polyethylene (XLPE) were produced by extrusion and cured by compression moulding. The samples were evaluated as insulation materials for extra-high-voltage direct current (EHVDC) cables by conductivity measurements in a threeelectrode setup at 30 kV/mm and varying degassing times. The CBNP nanocomposites exhibited lower apparent conductivity than unfilled XLPE under all tested conditions. For degassed samples (24-72 h) tested at 60° C, the nanocomposite exhibited approximately 3-5 times lower conductivity than neat XLPE, whereas at 90°C, the reduction was about 2 times. For the nondegassed sample tested at 60°C, the conductivity was reduced by more than 20 times. These results indicate that nanoparticlepolymer interfacial effects modify charge transport in the presence of crosslinking by-products. This was further supported by a MIDC-derived calculation on the discharge current, indicating an increase of traps with the CBNP addition. The chemical composition was further investigated using ATR-FTIR spectroscopy, which revealed only minor changes in the polyethylene structure, with a gradual increase in the carbonyl peak ( ∼ 1 7 3 0 c m- 1) attributed to mild oxidation or decomposition of peroxide crosslinking by-products.