In this work the application of polyelectrolyte complexes (PEC) to different pulps, to improve the strength of papers produced from them, is compared with conventional pulp beating. The pulps chosen for the investigation were a fully bleached chemical hardwood pulp (HBK), a fully bleached chemical softwood pulp (SBK), and a peroxide-bleached chemi-thermomechanical pulp (BCTMP). The polyelectrolytes used were a polyamideamine epichlorohydrine condensate (PAE), traditionally used as a wet-strength additive, and carboxymethylcellulose. Since the complexes prepared from these chemicals bear an anionic charge, they can only be used after fibre pre-treatment with the cationic PAE. Results indicate that the addition of 2% PAE and 2% PEC can improve all the measured tensile strength properties of the sheets as much as is commonly achieved by mechanically beating the pulps. In fact, for the chemical pulps, PEC addition at the chosen level produced better results than did traditional beating, since the improved tensile index and tensile energy absorption could be achieved without any significant deterioration in the light scattering coefficient of the papers produced. However, with the BCTMP a significant decrease in light scattering could be detected, especially following the addition of PEC. Adding the chemicals (especially the PEC) increased the sheet density, so chemical treatment left the bending stiffness of the sheets unaffected. However, based on the results, it was suggested that a combination of unbeaten HBK and BCTMP treated with PAE and PEC should be used as the fibre components of a typical fine paper furnish.